Fridge compressor location.

fredrussell

Well-known member
Joined
24 Mar 2015
Messages
3,472
Visit site
My boat came with a less-than-satisfactory peltier unit cooled fridge. I have a waeco compressor portable fridge but it’s a 31ft boat and at some point I’d like to get that space back by installing a compressor ‘driven’ cooling plate to the galley fridge.

The best place I can see for the compressor is the cockpit locker which is large, but unventilated. I realise compressor ideally needs to be in well ventilated spot but on a 31ft boat that’s not so easy. Does anyone have their compressor in cockpit locker and if so, how’s that working for you?
 

Keith-i

Well-known member
Joined
4 Jul 2012
Messages
1,440
Location
Jersey
Visit site
I have a remote compressor for the fridge on our motorboat. It sits in a locker in the wheelhouse but does have a couple of grilles to allow some circulation and venting. It all seems to work fine for us.
 

Daverw

Well-known member
Joined
2 Nov 2016
Messages
2,889
Location
Humber
Visit site
Only issue may be it getting too cold to condense properly, but you may not need it if this was the case unless you livaboard
 

samfieldhouse

Active member
Joined
18 Sep 2016
Messages
140
Visit site
On my 28ft-er the compressor is under the galley sink.
I actually converted a domestic mini fridge (front opening) that sits at the bottom of the hanging locker.
The gas pipe then is routed through the bulkhead to the compressor.

I used the GE80 kit and it’s been a complete epiphany. I spent 8 weeks ‘off-grid’ this summer with all power coming from my 2x 100w solar panels. Compared to my old peltier fridge… well there is no comparison! Hardly any power draw and it sits at about 1degeee.
 

Leighb

Well-known member
Joined
8 Aug 2007
Messages
6,877
Location
Suffolk
Visit site
You can get keel cooler systems which do not need ventilation as the heat is dissipated into the sea/river. A bit more expensive, but more efficient and quieter.
An alternative has the exchange elements in the engine sea water inlet, a bit less efficient but no need to drill holes in the hull.
 

Neeves

Well-known member
Joined
20 Nov 2011
Messages
13,104
Location
Sydney, Australia.
Visit site
We added a computer fan that draws cool air from the chain locker, which is pointing toward the wind :) when at anchor. The air is directed at the compressor, which is located in a recess at the top and back of the fridge, using normal domestic ducting, The fridge has an air gap all round, recommended for the installation, and I can 'feel' the warm air exiting into the galley. I have actually added to this and draw the air, or some of it, into the engine bay. Much depends on how much space you have for the ducting. The extra computer fan is wired into the compressor - fan comes on when the compressor cycles on.

Jonathan
 

RupertW

Well-known member
Joined
20 Mar 2002
Messages
10,267
Location
Greenwich
Visit site
You can get keel cooler systems which do not need ventilation as the heat is dissipated into the sea/river. A bit more expensive, but more efficient and quieter.
An alternative has the exchange elements in the engine sea water inlet, a bit less efficient but no need to drill holes in the hull.
Ours is in an unventilated space (although open a breeze through the bilge I support) under the cooker, but is water cooled - basically replacing the galley sink outlet seacock with a much wider external base designed to cool using the sea water temp outside. Seems to work very well.
 

fredrussell

Well-known member
Joined
24 Mar 2015
Messages
3,472
Visit site
Thanks for everyone’s input. I think cockpit locker will be my first try with it, in conjunction with a 12v computer fan.
 

Concerto

Well-known member
Joined
16 Jul 2014
Messages
6,152
Location
Chatham Maritime Marina
Visit site
My compresssor is in the large cockpit locker with a protective box surrounding it with large vent holes. No problems at all, in fact when I first started it up it turned into a freezer rather than a fridge.

It is also worth fitting an automatic switch so when you are connected to shore power, it changes to this rather than stay on 12V.
Dometic CoolPower EPS 100 - Mains adapter, connects 12/24 V
 
Top