Keith-i

Whilst it’s possible you may lose the gps signal and therefore your position data, you will still have the charts available on your...

Is there perhaps a blockage on the outlet pipe work from the filter which is causing a pressure build up in the filter resulting in the...

You would have to convert it into N2K as 183 doesn’t support engine data. It could be done with Arduino but it’s a steep learning curve...

That’s interesting. I wonder if you have a failing relay somewhere. I experienced an intermittent problem on my Audi Q5 which turned out...

I suppose you could swap the tacho over with the starboard engine and see if the fault follows. It wouldn’t surprise me if it was a...

Yes, I have the standard electrical system. The only customisation is a connection to the can-bus for my Arduino gateway to get data...

My 32 which is a similar weight usually gets sat on two sets of blocks stacked about 2 high. There is then at least 3 boat stands down...

Yes clean off the gelshield and abrade the gelcoat. I’m sure that would give you enough adhesion.

I think the real question is not so much whether your jalopi would run but how it might affect performance. We need a 0 to 60 comparison...

What about a DIN 12v plug. This one has a sliding red piece that means it will also plug into a standard 12v socket. In it’s DIN mide it...

I gave up on the cheap covers and bought a bespoke cover from Seaswan. It is 3 times the price but a much thicker grade of material with...

I chose Maxpower solely for being all composite under the water.

Could there have been some contamination present? Maybe oil or lubricant of some sort. I always clean surfaces/threads with some solvent...

That seems quite unusual unless there was some kind of damage or burr on the thread that ’wiped’ the sealant off the thread as you...

Can’t believe they will be compatible. The Co-ax will be sending a raw signal whereas the multi pin will be doing some processing with...