davidmh

I use both Fore and aft Guy and a topping lift, the pole is then fixed. On the aft guy I attach a snatch block to the forward end of...

I thought it states on the Y10 box do not use below 10 Deg C. I have found that this is true. David MH

Google For the DV 20 wiring diagram. there is the downloadable manual on the Bukh UK website and there is a diagram of the Bukh wiring...

Using a battery powered radio with FM the batteries last a fair time but change to DAB on the same set and the batteries do not last...

The OP wants to make a cockpit cover. Is he going to sail with the cover in place? If he is not sailing with the cover in place then he...

You can get brass countersunk inserts which you glue into the plywood. David MH

Why not check the ram position in maximum out position and min in position without the pin attached to the tiller. I should bleep when...

what exactly is pushing the pin off, Is the pin still upright at the end of the stroke. is the rod fouling the tiller or the bracket in...

On my DV20 I take the thermostat our each winter so I have to undo those screws, when I refit then I just grease them David MH

Vyv - yes beneath the hose. the other areas are on the outside of the case, it is clamped to to stainless shoe which does make contact...

Thanks for all the replies. Tranona - The halyard link was good, they have so good cylindrical waterlocks at a reasonable price but none...

I have a stainless waterlock on my boat, it normally lasts about 7 years before the corrosion from the exhaust gases causes a leak. It...

The pela is good but even with warm oils it takes a long time if you have to use the small diameter tubing. on by Bukh I take the...

I agree with Neeves, best way to install a radar cable on a small boat is to use the original multi core cable from the radar unit...

Often done to allow the incoming ferry to pass David MH