rsallo
Member
Hi everyone,
On my Halcyon the aft part of the cockpit floor, where the drain is, is lower than the rest of it. Here you have a couple of photos:
I'd like to raise it to the same level as the rest of the floor, or at least a bit higher (while keeping the drain open of course), but don't know how or with what.
I guess I could use a piece of wood, but it would be difficult to shape it to leave as little gaps as possible. Another alternative I can think of would be to fill it in with epoxy (with or without thickener), but I'm not sure it's the best way to do it, it looks too big to me.
Any suggestions?
Thanks!
On my Halcyon the aft part of the cockpit floor, where the drain is, is lower than the rest of it. Here you have a couple of photos:
I'd like to raise it to the same level as the rest of the floor, or at least a bit higher (while keeping the drain open of course), but don't know how or with what.
I guess I could use a piece of wood, but it would be difficult to shape it to leave as little gaps as possible. Another alternative I can think of would be to fill it in with epoxy (with or without thickener), but I'm not sure it's the best way to do it, it looks too big to me.
Any suggestions?
Thanks!