andsarkit

I would usually prefer to run separate cables for each device but a soldered joint can work well. If you use adhesive heatshrink and...

Generally that is something I avoid, but every time I have used a good heat shrink with a generous amount of adhesive, it easily sealed...

Lots of fenders. The other boat should be lying to the tide (if as you say not much wind) so either midships or forward cleat and tie...

It will be a real improvement. The keel is about a tenth the volume of a side tube and will take little time to inflate. The larger boat...

You don't say how far you want to move it. That will be quite a load even for a large 4x4. If you already have a decent cradle there are...

Next winter fit a longer forestay. Jimmy Green or your local rigger can easily make one up. When I fitted an inner forestay I reused an...

This is easy to check if you just remove the alternator belt and see if this improves starting. Some details on the different pulley...

Manufacturers usually quote efficiency at rated load because it looks good but if you are using a 1000w inverter at only 200w the...

Nylon absorbs water and will swell if immersed in water for long periods. I would hope that the manufacturers would have used acetal or...

Something like this:- Amazon.co.uk You can change the plug or even remove it and hard wire into your shore supply consumer unit. ( if...

I think they are just rather cheap and flimsy. I didn't like the look of them and reused the cast alloy A brackets from my old Vanessa hob.

Measure down from the existing square end and put several marks around circumference of the boom. Use insulating tape to go round the...

The alternator output pulse frequency is not the same as the engine rpm. There is a scaling factor which depends on the windings of the...

Yes, they are IP67 with an O ring seal and cable glands on the coax.

There is a Bulgin Bucanneer version for BNC. You could possibly do an in line connection with it.