billskip

Don't worry, it gets faster as you get older, you'll be turned 70 b4 you know it..... Enjoy your birthday..

I dunno...people will continue to get old, when I fall off my perch it'll be filled by another.

And you are here.........

You can only use rubber pipe (specialist exhaust hose) after the elbow where water is introduced, as far as I am aware. The water cools...

Sod's law

That flange looks like steel, so it looks possible to re use and just get a bend welded on. Just make sure the smaller pipe (water?)...

a valid Spanish driving license, specifically category AM, is required to drive a Citroën Ami in Spain

More likely McDonalds

Parts cost me about € 11. If you make one and have space use a bend rather than an elbow.

Problem with the one I had the flange was also rotten aluminium. I used it as a pattern and cut one with a mini grinder in mild steel...

I think here you have to have some sort of qualification...

Surley ,as in your photo irt would be possible to splice together at the top and bottom of the door opening

I had an aluminium one go on a perkins,at the time I was unable to find a replacement so I made one out of mild steel and a standard...

? Normally closed I think, so it closes and makes the circuit when it loses power.

Over the years I have run two MOB recovery practice sessions with a group of boats on moorings with a good tide running and volunteers...