Tool for rudder "nut"?

Joined
25 Feb 2010
Messages
12,982
Visit site
I don't know but the tool for removing disks on angle grinders may fit.

If not then it may well be quicker to make your own tool rather than chasing around trying to locate one.


Edit;
PS OK, it's a peg spanner!!! You learn something new on this forum every day.
 
Last edited:

Playtime

Active member
Joined
29 Jan 2007
Messages
1,194
Location
Chichester
Visit site
If you can take the weight off the thrust bearing (by lifting/jacking gently the rudder from underneath) you can probably remove the nut/bearing by hand. :)
 

savageseadog

Well-known member
Joined
19 Jun 2005
Messages
23,301
Visit site
Or pin wrench

I've made my own, it's possible to use screws as pins, preferably turned down but not essential
 
Top