carpetsauce
Member
I want to remove the tube cooling stack from the body of the heat exchanger on a Yanmar 3JH4E engine. I've removed both end caps but the tube stack won't budge.
Does the stack come out rearwards, towards the back of the engine?
Is there another fastener holding the tube stack in place that I've missed?
Does it twist? If so which way?
Should I protect the face of the stack with a piece of wood then whack it with a hammer?
Any jewels of experience from forumites will be gratefully appreciated.
Thanks.
Does the stack come out rearwards, towards the back of the engine?
Is there another fastener holding the tube stack in place that I've missed?
Does it twist? If so which way?
Should I protect the face of the stack with a piece of wood then whack it with a hammer?
Any jewels of experience from forumites will be gratefully appreciated.
Thanks.