TerryA
Active Member
Quick question. What voltage is the power supply to the DP290 drive? Just looking at the battery and wiring chaos and trying to dicide what is going where,
Thanks
Thanks
Volvo Penta DP290 Voltage
- Thread starter TerryA
- Start date
scottie
Well-Known Member
Is power not just 12v required for lift and or trim
Wiring diagram in w/s manual
Wiring diagram in w/s manual
Momac
Well-Known Member
You could check the relays on the trim pump which should have the voltage marked on them but I would be surprised if it's not 12 Volts.
Moodysailor
Well-Known Member
I'm confused?
What voltage are you asking about? For trim? For shift on EDC engines? For the engine itself?
The DP drives do not require any voltage to operate, they are purely mechanical.
What voltage are you asking about? For trim? For shift on EDC engines? For the engine itself?
The DP drives do not require any voltage to operate, they are purely mechanical.
TerryA
Active Member
Thanks. It was the trim I was asking about. It seems most likely to be 12v which leaves me with some more investigation.
