Refueler

I thought that at first .... but then water pump and heat exchanger are in odd positions for any Perkins I know of.

Think you also need to delve deeper ...... No doubt you'll question Volvo's use of Audi engines .. then the take-over of the design...

mmmmm could be taken 2 ways ... "plus it helps to keep my fees down." 1. helps to reduce marina increasing fees next year ...... or...

I know a well known Marina that lost a few clients because guys went round and measured LOA including any appendages / items left...

OTOH positioning will be easier, if that's an issue, than with a contact adhesive.

Why would it hurt to drain and leave ? Unless salt atmosphere gets in and starts corrosion .... but I would expect enough residual...

Geem .... go deeper into rebadging ..... Perkins was supplier of no-label engines to many ... usually in kit-box form ..... Even the...

Never had any reduction of fees for being away a few days or longer from berth .... my agreements were always an annual basis with...

Not Evo-Stick ... but for small to medium sized jobs - I use UHU Por Contact adhesive - which is plastic / foam safe ... and works with...

The yard who are sanding off the hull of my 38 ... are using the triangular orbital type with vacuum fitting to collect the dust. Guy...

Blimey - you really have a problem with it !! So where are you going to keep this big RIB ?? You've also missed the point that...

The BMW / Ford days were way later than the Perkins days ... you have to remember that Perkins were suppliers to many brands and also...

I'm talking PROPER LR's .... Series 2 .. 2A ... etc ... they had 2.25 Petrol ... the larger diesel was a Perkins and was advised to have...

I have to say a 240v Kettle is a must on my boats ...... once connected to shore - on with the kettle. Before leaving a berth and...

Doubt that ... most LR's for diesels used Perkins engines ....