vic008
Active member
Can I sort the size of them all by going on the length? Thats a reliable way of sorting?l
Are you trying to tell us that you knocked the container over & the whole lot has gone flying over the floor? ?Can I sort the size of them all by going on the length? Thats a reliable way of sorting?l
If they all came from the same set probably but if of mixed origin diameter is the way.Can I sort the size of them all by going on the length? Thats a reliable way of sorting?l
I have noticed that drill bits are the same length for a small range of sizes such as upto 2mm, then over 2mm to 4mm, etc.So..we can modify the advice...if using only one set of bits you can use length to sort them...but beware of broken bits as these will be very short...the good news is that it’s mostly the smallest diameters that snap.
Interesting...I don’t know what the OP’s setup is...but all my drill bit sets come in a case that can only accept the correct diameter and sometimes length. Perhaps the OP thought that it was just packaging and threw the case out???I have noticed that drill bits are the same length for a small range of sizes such as upto 2mm, then over 2mm to 4mm, etc.
No, but they are sharpened at the opposite endThe OP is from NZ... do the drill bits go in the opposite direction in the Southern Hemisphere...like water circling the plug hole ?