For Sale: Dometic Moonlight Three Cooker

lektran

Member
Joined
18 Feb 2020
Messages
66
Location
Gosport
Visit site
Three burner with grill inside the oven space
12v electric ignition (no AA batteries, connect to the house batteries) and oven light
Everything is in good working order

This was installed by the previous owner in 2019 but we haven't found it to be a good fit for the space since it prevented the use of the removable counter top and the safety bar, so we've replaced it with a smaller unit.

Asking £300, collect from Haslar Marina in Gosport
 

Attachments

  • 20231124_083611.jpg
    20231124_083611.jpg
    1.3 MB · Views: 41
  • 20231124_083636.jpg
    20231124_083636.jpg
    1.1 MB · Views: 40
  • 20231124_083654.jpg
    20231124_083654.jpg
    1.3 MB · Views: 40
  • 20231124_083723.jpg
    20231124_083723.jpg
    1.4 MB · Views: 38
  • 20231124_083745.jpg
    20231124_083745.jpg
    1.1 MB · Views: 38
  • 20231124_083811.jpg
    20231124_083811.jpg
    1.1 MB · Views: 37
  • 20231124_083834.jpg
    20231124_083834.jpg
    1.1 MB · Views: 42
  • 20231124_084916.jpg
    20231124_084916.jpg
    872 KB · Views: 41

lektran

Member
Joined
18 Feb 2020
Messages
66
Location
Gosport
Visit site
Sorry for the delay, bit worse for wear this morning.

The height on the specs that Hoolie mentioned is accurate at 435.4mm but it doesn't account for the pot holder rails. The true height to the top of those rails is 524mm.

The gimbal pivot location is 486mm from the base and 210mm from the front. The required swing radius is 535mm from gimbal pivot to the rear bottom corner and 528mm to the front bottom corner.

The true installation width required is 497mm, thats the width between the surfaces that the gimbal mounts would be installed on.

Hope that helps and sorry for the delay!
 

billyfish

Active member
Joined
6 Oct 2020
Messages
786
Visit site
I'm not sure it will fit , pity. I have 500 tall x 500 deep x 525 wide. I think it will stick up too much.
 

superboots

Member
Joined
26 Feb 2002
Messages
353
Visit site
I managed to fit this cooker in place of the original - its a squeeze. I don't use the pan guards so the worktop cover fits. However thee is hardly any swing room , the gimbals just hold the cooker in place.
 
Top