Uricanejack
Well-Known Member
A couple of questions about batteries.
My boat like most has two deep cycle batteries No 1 and No 2.
I have an isolation switch with the usual options
OFF, No 1, Both, No2.
In the past it was always my practice to regard one of my batteries as a house battery and one as a starting battery.
Using one battery only for lighting etcetera while at anchor or moored and keeping the other isolated and charged up so I would always be able to start.
Reading my owners manual it would appear this is a bad practice possibly causing damage. My owners manual recommends keeping on both and not changing position of the switch while engine running as this will cause damage. Why?
I would have thought if I run down 1 battery overnight if I switch to both to start it would cause my good battery to loos charge to the low battery. Damaging batteries. If not why not?
At the moment I believe my no2 battery is pretty much shot. While my No 1 is OK.
Had a problem earlier this year when both went right down. Both reading only about 7 or 8 amps Had to jump start the boat. My No1 battery seamed to recover my No 2 not so much.
It does charge up to about 13 amps but very quickly looses charge. And drops down to read well below 11.
My no 1 appears to hold charge.
It was my hope if I left cycling along with good battery it might recover.
Was this dumb?
It doesn’t appear to have worked.
If I replace my No 2 battery with a new battery and leave a possibly weakened No 1.
Will this deplete or loose efficiency of new battery?
Should I replace both batteries together.?
Is there a way of setting things up so I always have a fully charged battery?
My boat like most has two deep cycle batteries No 1 and No 2.
I have an isolation switch with the usual options
OFF, No 1, Both, No2.
In the past it was always my practice to regard one of my batteries as a house battery and one as a starting battery.
Using one battery only for lighting etcetera while at anchor or moored and keeping the other isolated and charged up so I would always be able to start.
Reading my owners manual it would appear this is a bad practice possibly causing damage. My owners manual recommends keeping on both and not changing position of the switch while engine running as this will cause damage. Why?
I would have thought if I run down 1 battery overnight if I switch to both to start it would cause my good battery to loos charge to the low battery. Damaging batteries. If not why not?
At the moment I believe my no2 battery is pretty much shot. While my No 1 is OK.
Had a problem earlier this year when both went right down. Both reading only about 7 or 8 amps Had to jump start the boat. My No1 battery seamed to recover my No 2 not so much.
It does charge up to about 13 amps but very quickly looses charge. And drops down to read well below 11.
My no 1 appears to hold charge.
It was my hope if I left cycling along with good battery it might recover.
Was this dumb?
It doesn’t appear to have worked.
If I replace my No 2 battery with a new battery and leave a possibly weakened No 1.
Will this deplete or loose efficiency of new battery?
Should I replace both batteries together.?
Is there a way of setting things up so I always have a fully charged battery?
Last edited: