Batteries Don't Explode

I found this thread distinctly alarming. How best to avoid this happening? Are some batteries safer?
Makes me wonder about wearing safety glasses when near batteries.

Had an odd one years ago. Viva van, knew it from new and on a cold day we had to jump start the genset at the airfield (no mains power) used the van battery and one other with fencing wire. Bit of a bang and the plugs blew out of the battery, spraying some acid about. We were puzzled, as the polarity was correct, then found it wasn't. Seems the van had been reversed polarity it's whole life (generator, not alternator) Good one from Vauxhall....
 
I found this thread distinctly alarming. How best to avoid this happening? Are some batteries safer?

Yes, AGMs are much safer, as I suggested in post 28. They have a much lower risk of exploding than flooded lead-acid batteries. AGMs can, however, in fairly rare circumstances generate excessive heat - a process called thermal runaway.

LiFePo4 batteries are even safer, but have cost and charging issues at the moment.
 
Whilst we are on the subject - from 2016 - how to explode a 'Lithium' battery
Cheers
Bob

That's lithium cobalt oxide. Lithium ion is a family of different chemistries. Of these, lithium ferrous phosphate (LiFePO4 or LFP for short) is the most stable thermodynamically as this somewhat dull but factual test shows. That is not to say that LFP is completely safe, as you sometimes read. Physical puncturing of a cell can release a toxic - although non-flamable - gas. Given the high energy density and a low internal resistance, a dead short releases very high current which can arc across a gap blown in the more usual main fuses used in marine lead acid installations, hence the recommendation of a Class T main fuse.
 
Last edited:
  • Like
Reactions: vas
That's lithium cobalt oxide. Lithium ion is a family of different chemistries. Of these, lithium ferrous phosphate (LiFePO4 or LFP for short) is the most stable thermodynamically as this somewhat dull but factual test shows. That is not to say that LFP is completely safe, as you sometimes read. Physical puncturing of a cell can release a toxic - although non-flamable - gas. Given the high energy density and a low internal resistance, a dead short releases very high current which can arc across a gap blown in the more usual main fuses used in marine lead acid installations, hence the recommendation of a Class T main fuse.
Very reassuring - thanks! Based on your very informative thread, we're already viewing our current set of (new-ish) AGMs as the last we'll own before moving to LiFePO4 longer term.
 
Top