Avon Rover R2.50 inflator adapter

[ColleyV8]

Read conflicting info about the valves and adapter on the rover inflatables

I got this with the new boat, but the footpump is just a length of hose

It looks like the twist in and lock adapter, anyone know what adapter to buy?

 

[Ribtecer]

Pump Bellows Pipe End Adaptor Fitting for Leafield Marine A4, A5, A7, B7, C7, D7 & A8 Valves¾” inside hose

This is what you need, nice dinghy by the way, one of the last high quality one's build here.

 

[Gsailor]

And that works out cheaper than 3D printing one which was going to be my suggestion (which means careful measurement and drawing with CAD BEFORE printing can commence)

 

[Ardenfour]

I have the same dinghy and use a short piece of 21.5mm plastic conduit. It's a tight, twist fit in the valve, same into the pump hose.

 

[Refueler]

I have 3 different valves in my inflatables (there are 4 inflatables at my home)..... 2 of which can take twist and lock ... but I inflate all with just push in pipe end adaptors. I don't find need to have Twist and Lock.

I use a 12v air pump for bulk ... then a few manual pump strokes to finish off.

 

[Mudisox]

I used to inflate my old Avon by using the car's exhaust. I now have an AB which has a twist and lock, but needs some rubber collars to ensure an air tight fit.

 

[ColleyV8]

Thanks everyone, ordered the kit above