Pagetslady
Well-Known Member
Hi I know we have had loads of posts about this generator but I am now having trouble with mine, last year it was sent back to Germany where they replaced the YAW brushes etc. under warranty, but it has been very noisy (even more noisy) since so I have replaced the bearings but now it doesn't appear to work at all. there are three wires that connect the coils to the the control panel board, they are marked (1) (2) & (3) I had to remove these in order to install new bearings, I thought I made a note of the order in which I disassembled but am now not sure they are now assembled in the following order (1) (3) (2) from left to right when looking at the unit from the front I am sure someone will have done this job before and can offer some help. I am reluctant to send it for repair again.
Regards Mike
Regards Mike
