yotter

Many thanks for the post, it makes sense. I do not expect the satin to less slippy than the polyurethane, this is not the reason for...

I am varnishing some internal areas and was previously advised to get a not too glossy hard wearing surface using International Compass...

As Tranona points out, its very important to seal off all holes/air gaps this is where most of the noise will come out even with...

As Tranona said, there is no replacement interval for the propeller shaft seals on those, they would only normally be replaced if there...

Thanks Tranona, I respect you words. I am not keen to disturb the lower end unless needed and if I did, I may well replace the O...

My boat is currently ashore and having change the saildrive VP130S oil is was nice and clear, so sign of water ingress. I do wonder and...

Outboard bracket got swapped round to the right way up And thats all folks! The Egythene 24 has been saved, and has allready been...

I have used ABS (Advanced Battery Supplies) several times and have visited their premises in Stockport, most impressive. They delivered...

Big thanks to all the marina and boatyard staff who were out checking on our boats through the storm - and were out again this morning...

....and long may your comments continue, Frank. Highly valued and much appreciated.

I have to assume that you make statements for a reason. Most people in these forums make statements but give no idea of their...

I do not know how much sailing you have done. Given a forecast of, say F5, I fully expect to see some F6, I accept that there could be a...

Ah don't worry, Peel Ports with be rid of it in no time at all:-)

Oh Wow, the Western ferries are off, must be windy!

8 sails shredded at Kip so far, keeping the sail-makers busy. Unthinkable to attempt to take them down at the moment. Gusting 70 knots...