Thanks Rhylsailor, I had just found the same advert.
This looks like the way to go, 10mm would be nice just need to check hole spacing and existing bottlescrews.
Cheers,
Rich.
Hi All,
I,m on the look out for 6 new shroud anchor points. The ones i have a the moment are a flat plate with a single hole triangle welded upright.
These are twin bolted through deck with large backing plate.
The design is fine but i feel the thickness is a bit under size and a couple of the...
We found our collie cross preferred to "drop in"through the forward hatch. We would make sure the berth infill was in position plus a few pillows. As he got older we built a little slide.
Getting out using the companion way with a bit of help from behind.
This was on a 30ft yacht so headroom...
Have you looked at wells next the sea, they have a slip way opposite the sailing club.
Plus sea wall or pontoon to rig on.
Just tides could be restrictive depending on keel configuration
Yes please, if still available.
Will pm details in the morning.
Many Thanks
Richard
Yes please, if still available.
Will pm details in the morning.
Many Thanks
Richard
I've done it in the past using narrow masking first, 5mm if you can still get it if not ten. It's easier to follow a curve.
And then mask half way with standard 25mm which can now bunch up where needed.
Hi Major,
We were there for a bout 4 years hopefully heading back soon.
Launching no problem at any tide as long as you stick to the slipway/ gravel areas, very soft mud especial to the left.
Also a small tender park within dragging distance. Only negative we had two tenders go missing, but I...
Hi Dolly...
I have one set up in the factory at the moment, based in Leicester so a bit far to travel but can help with photos and measurements
if of any use.
Richard.