There it is 👍, o ring should be 15.3 id, the ones in the aftermarket kits are clearly 16mm I’d and a loose fit on the shaft, I’ll grab the correct one and reassemble
Thank you
Kad32/ Ad31 raw water pump, Does anyone know the purpose of the o ring that sits along with the spacer between the two seals ( oil and water ), I understand both seals and the plastic spacer with castellations, the o ring appears to sit inside the castellations , is it some form of “flinger” to...
if anyone is changing out there old or broken KAD compressor clutch I’m looking for one, we need the little white plastic block in the wiring harness which is a rectifier diode as a spare, we’ve changed it out for a retro fit one but would also like an original just in case, happy to pay for it...
I’m trying to identify the little inline electrical block that both wires on our Kad32 compressor clutch wires pass through, is it some sort of suppression item ? it’s about the size of a small piece of Lego, white in colour, a red and a white wire go in one side and two black wires come out...
Thank you for all your replies, I’ve finally found it 👍, it’s the end cap on the oil filter housing ( under the oil cooler) looks like it may have corroded, just in the process of removing the unit and will confirm the fault but it’s definitely leaking from there , also is the heat exchanger a...
Hi all, we have a Kad32 engine in our Fairline Targa 29 which is dumping oil into the bilge when under load, probably a few litres on a run of less than 5 minutes, we’ve been round it with mirrors and torches and for the life of me I can’t see where it’s coming from , the sides of the block...
injection elbow
Hi, i have a 2020b engine and had all sorts of overheating issues and found the problem to be the 'water injection elbow' (the casting at the end of the heat exchanger where the hose joins), the hole where the sea water enters it was completely blocked and eventually i bought a...