eddystone

Borrowed heavy duty Sealey pump, miles better than my Pella

Really struggled to get ATF (O.6L) out of gearbox with Pella manual extraction pump. Seems I only removed less than two thirds after an...

It would but the thinner pin would be a very loose fit

OK thanks - looks OK then. Yes I do change ATF every year

Found the large flat shackle attached to my main sheet block would not fit the shackle on new car and had to add a further shackle -...

Got some ATF from chandlery in N Ireland as a make weight to get free postage for my anti-foul but noticed it’s multi vehicle ATF, D11...

I have Navionics on my tablet anyway the comparison is with old Garmin blue charts which I’m not even sure Garmin use now since they...

So I have a Garmin GPS Map750 7” chart plotter at the chart table which has Garmin Blue charts. I only really use it to show AIS...

I believe the hull was epoxied around 20 years ago so not when boat was new by any means. I have in the past made good some very small...

Useful information thanks. Think I’ll just put it off and do a better job scraping off loose stuff next winter!

Think next winter I need to get someone to sand/soda/coconut blast all the layers of anti fouling and primer back to epoxy paint. Any...

Impact driver (£17 from Machine Mart) and freeze release spray

Must be C series track as K series significantly smaller.

Latest update is managed to extract screws undamaged and remove track from boat. As someone has observed the track seems serviceable to...

Result! All 8 machine screws removed unbroken and track removed. Irony is that unsuccessful tour of Screwfix, Toolstation etc for a 10mm...