No P bracket just straight shaft log with cutlass bearing at one end and PSS seal at the other so no anode. The shaft seems central.
You can see why I am baffled. Thanks
Recently fitted a Darglow featherstream, replacing a fixed three bladed propeller. All works smoothly, forwards,reverse and feathering.
However, at about two thirds revs, I am getting vibration and noise which appears to come from the shaft log. Nothing has changed, cutlass bearing is not...
Have installed Waeco CU54 with VDO1 plate frodge running on 12v.
Want to have 240v feed through an inverter.
What is the best way to wire this system, please?
Want to fit new system to provide hot water from engine (Beta 35hp)
Can anyone tell me where to get all equipment needed at best price, please?
Ta very much.
I have a grease nipple on the rudder stock of my Colvic Countess 33 on which the thread has worn and the nipple is now loose.
The steering, a Whitlock cable system, works well and there is no play in the rudder so I am looking for a simple solution to my problem.
I would normally tap out the...
I need to re-engine as my raw water cooled Yanmar has come to the end of it's natural.
Any suggestions please as this engine is no longer produced and I wish to change to a fresh water cooled one to provide hot water etc.
Anyone with experience of replacing this particular engine could save me...
Tried everything, fuel system,raw water system, exhaust system. Definitely steam no oil/fuel in exhaust, no water in oil.
Its a raw water system, a cast lump both block and head. Did a petrol engine 30 years ago and have a manual. Am prepared to 'have a go' as so called mechanics charges are...
I think I have a leaking cylinder head gasket ( white smoke from exhaust).
Unable to find a local mechanic who fills me with any confidence I am going to remove the cylinder head to have a look and replace gasket if there is nothing any more seriously wrong with the head.
I have never done this...
My Yanmar 3HM35 runs smoothly, starts first time but emits white smoke which appears to be atomised, unburnt fuel, increasing with revs. Heavy load test when tied to dockside shows black/brown smoke at full revs.
Is there a simple solution or will I have to find a Yanmar mechanic to sort this out?
Yanmar 3HM35 raw water cooled engine shows steam/white smoke from exhaust increasing with revolutions.
Engine does not overheat.
Have replaced water pump, thermostats and water passing through anti syphon loop seems to be at moderate temperature with good flow.
Exhaust mixing elbow was...
I want to clean water passages in my Yanmar 3HM35 raw water cooled engine. I have heard that SAF acid and Ferroclean work well but I only seem to be able to get them in commercial quantities i.e. 25 litre drums at £8 per litre.
Has anyone any suggestions (other than stripping the engine down...