Sealong
Active member
Hello all,
My MD2030 is becoming difficult to start. The injectors were serviced about 50 hours ago and I replaced the glow plugs and relay at the same time. Yesterday, I changed the (two) fuel filters, they were clean with no sign of any form of residue, as was the glass filter bowl.
It will typically take two or three 30 second sessions of cranking it over before it starts. However, once started it runs and idles perfectly. There is voltage across the glow plugs and they draw current.
Any suggestions as to a likely cause would be much appreciated.
Chris
My MD2030 is becoming difficult to start. The injectors were serviced about 50 hours ago and I replaced the glow plugs and relay at the same time. Yesterday, I changed the (two) fuel filters, they were clean with no sign of any form of residue, as was the glass filter bowl.
It will typically take two or three 30 second sessions of cranking it over before it starts. However, once started it runs and idles perfectly. There is voltage across the glow plugs and they draw current.
Any suggestions as to a likely cause would be much appreciated.
Chris