Allan
Well-Known Member
I am going to fit an AIS receiver and need a VHF feed. Do splitters work and can anyone suggest a good one?
Many thanks.
Allan
Many thanks.
Allan
VHF splitter.
- Thread starter Allan
- Start date
little_roundtop
Well-Known Member
I would recommend a separate antenna and feed. A new antenna is not that expensive after all. Your VHF is really a piece of life-saving equipment so (for me at least) a splitter is a bad idea.
DipperToo
Well-Known Member
+1 - also the AIS aerial is 'tuned' differently to a 'standard; VHF aerial so I am led to believe. Also, if it is mounted on the pushpit, it should work as an emergency VHF aerial.
pvb
Well-Known Member
Not so, AIS uses frequencies in the marine VHF range, so a standard VHF antenna will work fine. However, a splitter isn't necessarily a good idea; maintaining the integrity of the VHF radio system is important.
yachtorion
Well-Known Member
I have a Glomex RA201 AIS splitter and it does a great job of driving my ICOM VHF, DigiYacht AIS Receiver and stereo. I've not seen any issues with it and AIS performance seems excellent, VHF performance also.
It's available for about £65 online, but be careful not to accidentally buy the cheaper non AIS version (which just splits out for the VHF and stereo).
If you do get a problem with the VHF, the splitter goes into a bypass mode when power is removed from it, and in the worst case you can always just disconnect it and plug the antenna in directly to the VHF.
That said, if you can do it, the extra antenna option *is* superior.
Which AIS receiver are you getting? Some of the cheaper ones aren't dual channel, they just switch between channels every X seconds. But the Digital Yacht ones are brilliant - mine is the AIS 100 which I picked up for about £120.
It's available for about £65 online, but be careful not to accidentally buy the cheaper non AIS version (which just splits out for the VHF and stereo).
If you do get a problem with the VHF, the splitter goes into a bypass mode when power is removed from it, and in the worst case you can always just disconnect it and plug the antenna in directly to the VHF.
That said, if you can do it, the extra antenna option *is* superior.
Which AIS receiver are you getting? Some of the cheaper ones aren't dual channel, they just switch between channels every X seconds. But the Digital Yacht ones are brilliant - mine is the AIS 100 which I picked up for about £120.
Allan
Well-Known Member
I have an Icom IC-M501EURO VHF with DS-100 SCA unit. Both have aerials, the DSC one is the old dgps unit one on a pole with the one of my GPS domes. I plan use that with the AIS and split the main aerial between VHF and DSC.
Allan
Allan
yachtorion
Well-Known Member
The glomex splitter has a VHF connector labelled as VHF and a BNC connector output labelled as AIS.
I'm not sure whether they are designed to filter the signals based on frequencies, putting the AIS frequencies down the AIS line or not.
Therefore I don't know if it would be suitable for the task you want it to do, and I suspect the only people that would be sure are the manufacturers.
For not all that much more than the splitter you could buy an ICOM MC-411 radio with integrated DSC. Not as posh as the 501 but brand new and a lot more compact...
I'm not sure whether they are designed to filter the signals based on frequencies, putting the AIS frequencies down the AIS line or not.
Therefore I don't know if it would be suitable for the task you want it to do, and I suspect the only people that would be sure are the manufacturers.
For not all that much more than the splitter you could buy an ICOM MC-411 radio with integrated DSC. Not as posh as the 501 but brand new and a lot more compact...
Salty John
Well-Known Member
Correct - the VHF marine band runs from 156 MHz to 163 MHz. AIS is at the 'right hand' edge of the range - 161.975 and 162.025. Typically, performance will drop off towards each end of the band. A good vhf antenna will have sufficient bandwidth so that even at the extremities of the band it performs satisfactorily, say better than 1.8:1 SWR.
Some vhf antennas have relatively narrow bandwidth and may not perform very well, lets say worse than 2.0:1 SWR, beyond 160 MHz. Such an antenna might have an SWR of 3.0:1 by the time 163MHz is reached so AIS performance might be compromised.
An AIS optimised antenna will be centred further to the right of the band so that its performance is good at 163 MHz.
If you ever intend to use your AIS antenna as a back up for your radio antenna, choose a good quality standard vhf antanna. If you want an antenna specifically for AIS, by all means select an AIS optimised antenna.
With a splitter, you should use a standard vhf antenna of good quality.
Allan
Well-Known Member
I have an Advansea AIS RX-100 which is dual channel. It also has a USB output for use down below.
It cost me £100 earlier this year.
Allan
PabloPicasso
Well-Known Member
Yes I have this system and it is only an ais receiver but works well displaying ais vessels on my plotter and allowing good vhf performance. As he says, if the splitter fails you can always by=pass it
+1
Allan
Well-Known Member
I think I'll look around at various splitters before I fit the unit next week.
Thanks for the help so far.
Allan
Thanks for the help so far.
Allan
William_H
Well-Known Member
VHF antenna
A s said and seconded you are much better off with another VHF antenna on the stern rail for use with AIS and also available as an emergency VHF antenna. Splitters are OK but the idea of firing 25w of VHF transmit power into a splitter hoping that it won't damage the AIS receiver is something I would want to avoid.
If you follow these forums you will see that a lot of people have trouble with mast top antenna and the cable to it. A standby antenna would be very useful. I use a stern rail mounted antenna for VHF com and it has always performed adequately. olewill
A s said and seconded you are much better off with another VHF antenna on the stern rail for use with AIS and also available as an emergency VHF antenna. Splitters are OK but the idea of firing 25w of VHF transmit power into a splitter hoping that it won't damage the AIS receiver is something I would want to avoid.
If you follow these forums you will see that a lot of people have trouble with mast top antenna and the cable to it. A standby antenna would be very useful. I use a stern rail mounted antenna for VHF com and it has always performed adequately. olewill
