Small Outboard Steering

[kristofferstahl]

Hi Everyone!
So, Im completely new to outboards and stuff but what is the cheapest way to "connect" an outboard motor to a jockey console, with both steering wheel and throttle control box. the thing is that my old honda 7.5 4stroke is not made for remote controlling. Ive heard about those hydraulic steering kits/bundles where you get all you need, but its bloody expensive! Hope you will help me remember it will be mounted to a RIB/Tender inflatable boat

 

[TQA]

You can get mechanical systems like this where a push pull cable is used http://www.westmarine.com/buy/teleflex--safe-t-quick-stern-drive-rotary-steering-system--P006_182_001_002

 

[kristofferstahl]

Ok, so can you also turn the outboard with this or is it only for throttle control? dont blame me, i know im stupid

 

[Tranona]

Unless there is a remote kit available for your model you cannot fit remote steering or throttle/gear controls. The steering unit suggested assumes the outboard is set up for remote steering, which is brackets to take the push rod. You also need the brackets to attach the cables for the throttle and gear shift. This is what you get in a kit. The cables and remote controls are standard items.

 

[scottie]

Cheapest steering would be wire and pulley system but only suitable for small HP

 

[Spi D]

Wire and pulley not nice to run along the inside tubes on a rib, especially when talking 'jockey console'.

The outboard must be ready for remote steering and engine control, as mentioned. That said, cable steering and single lever remote box is the least expensive - but not inexpensive

Looking at some £400 + plus seating if the engine is ready.
http://www.ronhalemarine.co.uk/superbasket/product/1224/Pedestal_Steering_Systems_8-12ft_up_to_40hp