Hacker

You would put a strip around the perimeter of the base and around the screw holes. Put a bit around the screw heads when you put them...

+1 for butyl

As I said above that’s where we moored. It’s fine unless you get an easterly then it can get bouncy. All the moorings are full chain so...

I used to keep our Crabber on a swing mooring off the Greenbank. When I first tried to insure her (with Y yachts) they wanted her out...

Also wipe over with acetone after sanding (and wear decent gloves, acetone is nasty and will melt cheap latex gloves).

Some recent quotes just for illustration (all rounded). GWJ. 698 Nav & Gen. 720 Pants. 779...

Got quotes from all their brokers; Craftinsure were by far away the cheapest

Could it be crevice corrosion rather than galvanic? If it was in the mud then no oxygen would get through.

I did pop into the office on Thursday and mentioned the thread.

It was a colloquial expression!

He didn’t create Tesla, he bought it out from the guys that set it up.

Why is that more flexible? Are you a qualified marine electrician?

No, they act as brokers. They possibly act as finders as well but so will most brokers if it’s worth their while.

Cedar strip plank with epoxy sheathing makes a strong long lasting hull. Not a difficult technique if you can make or buy correctly...

If you have access to eglass and epoxy (and have the skill) it’s easy to lay up a thick sheet yourself. You could either do a large...