Portofino
Well-Known Member
Having read through this thread , I would be very weary .
Principly an old sterndrives with what seems little or no history -DIY without spares invoices -I would walk .
The high moisture content is not exactly what you need to hear particularly if the boat is cored .Coring is a cheap way to build a hull by using less resin /matting -it saves wieght so lower engine power is needed for a given speed .
Find a small old shaft drive boat -I,am not convinced older Sealines are the way to go .
At the Mech survey you really need to find out when the drive oil ( invoices please ) was changed .
Problem is this if it's been DiY ,d while the boats been stood for 9/12 then you will not know if it's milky .
Cos he,s disguised a seal leak -by refreshing the oil .
If its milky before you put it in the water -walk away .
If it milky after the sea trail -walk away .
At that age without invoices to say otherwise -milky oil may NOT be just a simple seal -more likely a drive rebuild £1000 +
Marine engines really should have annual oil change -to remove build up of acids which are corrosive .
This is fine in regularly used car -extended oil changes say 20K every 2y or what ever cos reg use keeps the oil moving .
In a boat it's stud with the engine off for weeks / months -the acid just sits in the bearing journals doing harm.
That's another tell tail -where are the invoices ?
iPad double post sorry folks :nonchalance:
Principly an old sterndrives with what seems little or no history -DIY without spares invoices -I would walk .
The high moisture content is not exactly what you need to hear particularly if the boat is cored .Coring is a cheap way to build a hull by using less resin /matting -it saves wieght so lower engine power is needed for a given speed .
Find a small old shaft drive boat -I,am not convinced older Sealines are the way to go .
At the Mech survey you really need to find out when the drive oil ( invoices please ) was changed .
Problem is this if it's been DiY ,d while the boats been stood for 9/12 then you will not know if it's milky .
Cos he,s disguised a seal leak -by refreshing the oil .
If its milky before you put it in the water -walk away .
If it milky after the sea trail -walk away .
At that age without invoices to say otherwise -milky oil may NOT be just a simple seal -more likely a drive rebuild £1000 +
Marine engines really should have annual oil change -to remove build up of acids which are corrosive .
This is fine in regularly used car -extended oil changes say 20K every 2y or what ever cos reg use keeps the oil moving .
In a boat it's stud with the engine off for weeks / months -the acid just sits in the bearing journals doing harm.
That's another tell tail -where are the invoices ?
iPad double post sorry folks :nonchalance: