3571
Well-Known Member
Do any forumites know exactly which shaft and prop nut anodes are required for a Jeanneau MF925?
Thanks in advance for any help.
Thanks in advance for any help.
Merry Fisher 925 Anodes
- Thread starter 3571
- Start date
PaulGooch
Well-Known Member
The MF's are fitted with conical anodes, MG Duff CMAN 235, CMAN 240 or CMAN245 depending on shaft size. Aparently, the MF 805, which i have, had a choice of 35mm or 40mm shafts, mine is 35mm. There may then be a choice for yours, although i'd guess 40mm.
http://www.mgduff.co.uk/mgduff-product-catalog/The+%91Martyr%92+range/Beneteau+type+prop+nuts/
It may be worth a call to a decent MF dealer. I found Morgan Marine at Brightlingsea to be extremely helpful. http://morganmarine.com/
Philiz
Well-Known Member
Will also probably depend on which engine you have as I think there were options. Just measure your shaft is probably the safest way of making sure you get the right one.
bluejasper2
Well-Known Member
40mm cone anodes same as my benateau 9 next door boat 925 was same as mine hope this helps £13.45 from swindlers
3571
Well-Known Member
Thanks fellas.
The engine is the 285HP Volvo KAMD300, and the shaft is 45mm if I remember correctly, but I will check again.
I spoke to a dealer a while back but he seemed to have as much idea as I had, something about although it was a 45mm shaft, the prop nut anode was not a 45mm one which confuddled me just a tad (maybe it's 40mm as bj2 suggests?). He was going to find out properly and let me know, but never did for whatever reson.
I have emailed a couple of other J dealers yesterday on the subject, no answers on phones, they are possibly boatshowing drooling over JFMs new toy.
Nowt simple with boats eh.......:-(
The engine is the 285HP Volvo KAMD300, and the shaft is 45mm if I remember correctly, but I will check again.
I spoke to a dealer a while back but he seemed to have as much idea as I had, something about although it was a 45mm shaft, the prop nut anode was not a 45mm one which confuddled me just a tad (maybe it's 40mm as bj2 suggests?). He was going to find out properly and let me know, but never did for whatever reson.
I have emailed a couple of other J dealers yesterday on the subject, no answers on phones, they are possibly boatshowing drooling over JFMs new toy.
Nowt simple with boats eh.......:-(
PaulGooch
Well-Known Member
I have a spare cutlass bearing in the workshop. Just been and measured it up and it's for a 40mm shaft. Yet, my MF805 uses the 35mm anode. Time before last, i ordered the anode from Westways (Jeanneau dealer) and they sent a 40mm one, i guess they looked the shaft size up.
Given that and bj2's comments, i'd be inclined to get a 40mm anode, unless you can physically measure the nut itself.
When you know for sure, write it in the service book for future reference.
