DownWest
Well-Known Member
Ian, do you know the diameter of the tube? I can make up the ss bits for 3sp and get them over to UK in a couple of weeks with a passing friend.
Lifting centre board
- Thread starter 3speed
- Start date
ianc1200
Well-Known Member
Yes, will check tomorrow as long as not too wet.
ianc1200
Well-Known Member
There doesn't seem to be any tube as such, but the black part of the fitting is 1.004" diameter. Mine has the wire proud of the whole fitting and a SS flange, which is not original.
DownWest
Well-Known Member
I have just had a look at the Kelt and it is the same H-A part! The tubular shaft is 20mm, or poss 3/4 inch, I will take a caliper out.
Offer still open to run up a shaft and get it to you end of April. Cost of postage.
DW
Edit: The tube is 19mm/ 3/4"
Offer still open to run up a shaft and get it to you end of April. Cost of postage.
DW
Edit: The tube is 19mm/ 3/4"
Last edited: