Garmin 4008 experience

sand_dune

Member
Joined
7 Apr 2014
Messages
70
Visit site
Hello,

I just bought a boat that I will only be able to visit again in 2-3 weeks time. I have once viewed the boat, and the seller had to shortly use an on board GPS Garmin 4008. It was really painful to watch (and I had a go at it too) attempts to position the map over a specific location, which was the town of Brighton. There was a sort-of-mouse-pointer on the screen. When using direction keys it would move across the screen, while the map wouldn't. Once the pointer hits the side of the screen, nothing happens, but after a few seconds the map would race in the direction of a pointer uncontrollably, flying over the location you intended to view. Because of that the map has then to be moved in the opposite direction to return to the intended location. So we again start moving the pointer across the whole screen(and it moves slowly) and the map would race again. Very hard to focus on a specific location. I'm sure there should be a better way of controlling the map on such expensive device like Garmin GPS 4008?

Please advice me, so I can stop worrying about this. I don't necessarily need to know the exact procedure, I could figure it later. I'd be simply relieved to know that there exist non frustrating ways of using that GPS device.

Thanks!
 
Last edited:

richardbrennan

Well-known member
Joined
10 Dec 2008
Messages
1,596
Visit site
I had a Garmin 2010 which has an almost identical keypad setup and I cannot recall having this problem. There is perhaps on option in the setup that allows you to control the speed of the pointer. I would suggest giving Garmin a call, I have always found them extremely helpful. I now have a 5012 which is touch screen so cannot compare this with your 4008, but I believe they are basically the same as they share the same instruction manual.
 

Ripster

Active member
Joined
20 Oct 2008
Messages
2,191
Location
Torbay
Visit site
I had a Garmin 2010 which has an almost identical keypad setup and I cannot recall having this problem. There is perhaps on option in the setup that allows you to control the speed of the pointer. I would suggest giving Garmin a call, I have always found them extremely helpful. I now have a 5012 which is touch screen so cannot compare this with your 4008, but I believe they are basically the same as they share the same instruction manual.

+1 I have had a 4008 4012 and now have a 4010. No issues with pointer control. Great plotters IMO.
 

sand_dune

Member
Joined
7 Apr 2014
Messages
70
Visit site
I know a lot about PC, but not about navigational equipment, I hoped that the plotter would have a better mode, that does the job. I feel encouraged by your answers, thanks!
 
Top