Dantp
Active Member
I am trying to get make my Victron Bluesolar MPPT's equalise my Batteries.
Previously I've just used shore power when stopped in a Marina but its been a while since I've been to one.
Using the Victron VE direct cable I can set my equalisation voltage and the frequency I want to equalise. I set this to every day to try and force it into equalisation mode the same or next day, when I could be onboard to monitor it.
My Batteries got to fully charged (smart gauge battery monitor) about 1pm and both my MPPTs went into float. This repeated the following day.
When I look with the connected laptop they don't show a period of time of equalisation. Just bulk, absorption and float.
Has anyone managed to get an equalisation cycle to run with a Victron MPPT?
How did you so it?
Am I doing something obvious wrong?
Thanks.
(400W of Solar connected with 2x 15/75 MPPTs).
Previously I've just used shore power when stopped in a Marina but its been a while since I've been to one.
Using the Victron VE direct cable I can set my equalisation voltage and the frequency I want to equalise. I set this to every day to try and force it into equalisation mode the same or next day, when I could be onboard to monitor it.
My Batteries got to fully charged (smart gauge battery monitor) about 1pm and both my MPPTs went into float. This repeated the following day.
When I look with the connected laptop they don't show a period of time of equalisation. Just bulk, absorption and float.
Has anyone managed to get an equalisation cycle to run with a Victron MPPT?
How did you so it?
Am I doing something obvious wrong?
Thanks.
(400W of Solar connected with 2x 15/75 MPPTs).