Cutlass bearing size

[snowbird30ds]

I have a princess 30ds and need to know what cutlass bearing to order and make a puller, I have 1.5" shafts and it seems there is options of 2" or 2 3/8" outer diameter.
Does anyone know which it is likely to be? The boat is 90 miles away and I would like to get them changed next friday afternoon and back in the water.

 

[volvopaul]

I have a princess 30ds and need to know what cutlass bearing to order and make a puller, I have 1.5" shafts and it seems there is options of 2" or 2 3/8" outer diameter.
Does anyone know which it is likely to be? The boat is 90 miles away and I would like to get them changed next friday afternoon and back in the water.

Unless you have changed them before do you know what you could be up against.
Do you have a prop puller and a tool to press out or drift out the bearings? You may have to remove the shafts to knock them out. Princess are generous on size so I'd say the outside diameter is 2 3/8 .

 

[snowbird30ds]

I've had the props off with hydraulic puller and plan on making a puller for the bearings, I was hoping they might be 2" as I have some tube with 1 1/2" ID and 2" OD that I could split down for the job.

 

[omega2]

www.clementsmarine.co.uk Paul Williams might be able to assist?

 

[snowbird30ds]

Going to give clements a bell in the morning as Paul has just done my props for me, any idea if I am likely to have grub screws or just push fit?
As you can tell I'm not used to shafts as always had outdrives before, the setup is twin TMD41's on 1 1/2" shafts.

 

[omega2]

sorry no idea, but he will

 

[snowbird30ds]

Got the answer, 2"OD 6" long, got someone local to the boat to measure for me.