dylanwinter
Well-Known Member
Just looked at the pix for the latest revelation…
![]()
Strikes me that the lump of green metal as well as being a means of propulsion (or not) may also form a substantial part of the ballast, helping keep the beastie on its feet.
If removed, should some compensating weight be added low down?
ballast is cheap
for starters I am planning on carrying a spare outboard - three domestic batteries - the space will make a handy dog kennel - the vented stern locker will be full of fuel cans, I thought I might put a nice park bench across the stern
if the boat does not come back on her lines then I can always do what the old Humber Yawl blub sailors used to do and that is to put a few bags of beach gravel in the bilges.
Heck the boat might go even better without the 250kg lump.
There are a few quotes here from an American who ran Centaur with the an outboard on the stern
http://www.keepturningleft.co.uk/scuttlebutt/moving-a-centaur/
"I purchased my Centaur used without the original Volvo inboard, so my only experience with it, is with the outboard motor. I think the outboard is a compromise to an original inboard for a few reasons I have used a 9.9hp outboard motor, which is adequate, but I think minimal for my particular inland coastal sailing area. It is hung off the stern with a typical store-bought outboard motor bracket.
The prop will also be out of the water when healing if you’re power-sailing. On the positive side, the boat can be maneuvered quite well in tight areas, like docking, by swiveling the outboard and rudder at the same time, both forward and reverse. This same method works well in helping to wiggle out of shallow water.
The biggest problem I’ve encountered is in rough seas, when the boat is pitching violently fore and aft, that the prop is sometimes out of the water and then the motor is totally submerged. This is an extreme case, but not fun when you need the thrust of the motor most. The other negative is having to reach over the stern to operate the controls. Also, I can only assume that the boat would handle differently (better) with the ballast of the original engine in the bilge, where it belongs, "
D