Can anyone identify these raw water strainers?

The lid is absurd as well, must be made out of unobtanium, time to take them off and get some made if I can't find anywhere that does pattern.
 
Volvo prices are scary.

If youre replacing the assemblies there’s bound to be cheaper options. Not a complex item after all
 
I had two plastic 90mm diameter, 10mm thick (acrylic) spacers made by plexico-uk who sell on e-bay.
They advertise plastic disks, so I contacted them with a brief description. They cut the material with a laser. £7 each didn't matter how many holes/size/position. Arrived in 24 hours - perfect.
Worth measuring up and getting a quote for a pair in polycarbonate ? thinking about it at the thickness you have acrylic would be OK too.
 
Last edited:
I had those strainers on my last boat. If its just the lids that need changing, they're just thick acrylic / perspex. Take one as a pattern and find a local place to make new ones for you.
A tip for the o rings, apply a smear of silicon grease.
 
Thanks everyone, I had to look at the Volvo prices three times!
I'll go down the "get them made" route.
Replaced the air filters with Bosch, trade price was under £10 each, the coarse filters are Separ KWA 90M's, fine fuel filters I'll probably use oe and the same with oil filters.
Just starting going through stuff now we're on our home mooring.

20180101_155546.jpg
 
You must log in or register to reply here.

Other threads that may be of interest

S
VP 41 raw water capacity
Replies
0
Views
72
snowbird30ds
S

Share this page

Top