mad_boater
New member
Has anyone had the propshafts out?
360 Statesman propshaft again
- Thread starter mad_boater
- Start date
Elessar
Well-known member
it's easy on the 360 compared with the 390. You don't have a cabin in the way!
Yes in answer to your question.
mad_boater
New member
Great
Does the shaft have a second cutlas bearing inside the shaft seal?
Does the shaft have a second cutlas bearing inside the shaft seal?
rosssavage
Active member
Yes. It's very likely you'll have to remove the whole assembly to replace it. Getting to the set screws then removing the bearing in situ is nigh on impossible.
superheat6k
Well-known member
Having just replaced seal and cutlass on my Turbo 36 (the Devil's work) i wrote it up as a procedure. If you want a copy send me your email and I can send you a link.
mad_boater
New member
PM sent
mad_boater
New member
rosssavage
Active member
Spares for what? Cutlass is a standard bearing cut in half - same dimensions as the P-bracket bearing but half the length. Readily available from various manufacturers / vendors. Nick at Seabridge marine is your friend.. 
If you mean seal spares, depends on which seals are fitted.
If you mean seal spares, depends on which seals are fitted.
Last edited:
