360 Statesman propshaft again

[mad_boater]

Has anyone had the propshafts out?

 

[Elessar]

Has anyone had the propshafts out?

it's easy on the 360 compared with the 390. You don't have a cabin in the way!

Yes in answer to your question.

 

[mad_boater]

Great

Does the shaft have a second cutlas bearing inside the shaft seal?

 

[rosssavage]

Yes. It's very likely you'll have to remove the whole assembly to replace it. Getting to the set screws then removing the bearing in situ is nigh on impossible.

 

[superheat6k]

Having just replaced seal and cutlass on my Turbo 36 (the Devil's work) i wrote it up as a procedure. If you want a copy send me your email and I can send you a link.

 

[mad_boater]

Having just replaced seal and cutlass on my Turbo 36 (the Devil's work) i wrote it up as a procedure. If you want a copy send me your email and I can send you a link.

PM sent

 

[mad_boater]

it's easy on the 360 compared with the 390. You don't have a cabin in the way!

Yes in answer to your question.

Do you know who's system is used ( for spares)
Thanks

 

[rosssavage]

Spares for what? Cutlass is a standard bearing cut in half - same dimensions as the P-bracket bearing but half the length. Readily available from various manufacturers / vendors. Nick at Seabridge marine is your friend..

If you mean seal spares, depends on which seals are fitted.