Recent content by drew silverwitch

I have exactly the same issue only leaks when its cold I got some of this RLD2 RING AUTOMOTIVE Coolant Leak Detection Dye (RING LEAK DETECTION) LIGHTING | eBay It glows under uv cofirmed the water was comming from engine but i still cant find where

Have been in a love hate relationship with my 030 for years. As explained to me years ago the gauze is not there to act as a filter, it is to increase the surface area of hot metal with the fuel, this helps the fuel vaporize more efficiently in a cooler burner at a lower pressure. Mine has a...

mine run at approx 80c at displacement speed anf get up to 90c when on the plane for any length of time, been like that for years

I have one. It has never transmitted but recieves fine. Tech support forget it. They still appear on Amazon and Ebay sold from alledgedly UK sellers. Bull Best thing to do with it is take it to your nearest electrical waste facility and leave it there

Normally the sump has the deep section at the flywheel end (rear) of the sump. In a vehicle you often find a cross member under the front and even here the engine often slopes backward. Is the strainer mounted on a shaped pipe if so it may just need turning where it enters the pump housing

https://www.screwfix.com/p/lubetech-black-white-oil-spillage-absorbing-pads-400mm-x-500mm-25-pack/62576 Bought a pack 3 years ago still useing them work very well catching drips and spills under the engine, ant water under there comes out oil free

I use this quite often Not weather forecasts but I find it useful http://wavenet.cefas.co.uk/Map

I tried Amazon and as it was more than 30 days they refused, I believe this is another difference with Amazon market place that is not made very clear. The Amazon 123 guarantee is only 30 days anyway

That's very kind of you could I get in touch after the Easter break

Self amalgamating tape available from DIY shops I used 2 BNCs and a barrel connector on both VHF and GPS then wrapped with two layers. they have been there for 4 years and when I put the swr meter on the VHF last week still got a good reading

Thanks for insights the unit is 6 months old bought new via Amazon from what i believed was a uk based seller, turns out they were not UK based and don't want to know. Matsutec don't want to know, so stuck really. It has its own aerial and I have checked with others who have a receiver and they...

I have a matsuetec HP33a transponder that will not transmit, it has the mssi set and recieves perfectly Does anyone know of a repair agent in the UK Matsutec do not want to help as they seem to have discontinued this model TIA

Having just had a tank fitted what would you recommend putting in it to stop smells and help break stuff down

Expierience of building marine ply dinghies and canoes, we used to pin them with brass panel pins and seal them in. Never had an sssue with them

I use the same rig as I use for casting fishing weights with a different ladle so as not to contaminate the zinc with lead. Old shaft anodes and the remains of disc annodes are remade into disc annodes for trim tabs and rudder. For a mould I just press a disc anode into casting sand in a box, I...