Volvo/OMC Trim Sender

[ballena]

went down to the good ship Ballena in the week to remove the props, only managed to get the rear one off the DP shaft as this had a normal 30mm nut, where do I get the tool to remove the other, anyonein the portsmouth area got one I could borrow?

I also noticed that one of the wires to the trim sender was broken so I removed it and dug out the potting to find that another was never even soldered to the potentiometer , anyway i've soldered three nice new wires to it and re-potted it tonight so should be able to re-fit it in the morning, any advice on adjustment?

Now its time to antifoul her, I am considering Blakes Tiger, any views?

Lots of questions but i'm just so pleased we made the decision to keep her.

Any advice on the above really appreciated

Thanks

<hr width=100% size=1>V8's rule!

 

[Talbot]

Pepe's Boatyard at Hayling Island has some prop spanners that are open ended, so suspect these might be what you are after. Sorry I dont know their size, but they will know if it is the correct item

<hr width=100% size=1>