tillergirl
Well-Known Member
Moan, moan, fidget, moan!
Didn't work once I'd cleaned it either since the fairing block is obviously equally covered!
The slightest thing and they stop working!
- Thread starter tillergirl
- Start date
Moan, moan, fidget, moan!
Didn't work once I'd cleaned it either since the fairing block is obviously equally covered!
Habebty
Well-Known Member
Yep.....my Navman log too! Anyone know why the Navman log impellors are such a pain to withdraw, takes all my strength to pull the impellor up or push it down again even when lubed with Teflon?
FullCircle
Well-Known Member
I use a toothbrush through the handle and twist back and forth in a gentle upward drawing motion. Then I use the toothbrush toi clean it with. It sits there all the time.....
Marmalade
Well-Known Member
Same here - fed up with cleaning it, relying on gps sog now
johnalison
Well-Known Member
Never have trouble with mine -Raytheon (as was)
MoodySabre
Well-Known Member
At least you can fix it - Sheila pulled the engine stop handle once we had picked up a buoy today and it came right out 
Another few quid for Mr Penta
Another few quid for Mr Pentatillergirl
Well-Known Member
Ah, Judy did that once. "YOU told me to pull it" she said! As I recall, the nipple just needed replacing.
First play with the figures suggests a line of at least 1.1m at CD where we discussed. I have to check my interpolation though. I'll PM you the draft. Also could not find that anomaly outside the beacon so I reckon it was a huge cod.
First play with the figures suggests a line of at least 1.1m at CD where we discussed. I have to check my interpolation though. I'll PM you the draft. Also could not find that anomaly outside the beacon so I reckon it was a huge cod.
Wunja
Well-Known Member
It took about an hour of seawater immersion at the weekend, to free up the log from the fresh water slime... or maybe it was just bouncing off the top of a large number of waves.