Stainless welder/fabricator in/near Brighton ?

[Boo2]

Hi,

I already know about Stainless Steve but I just wondered if anyone here can recommend a Stainless welder/fabricator a bit nearer to Brighton, East Sussex ?

Thanks,

Boo2

 

[SolentPhill]

Hi,

I already know about Stainless Steve but I just wondered if anyone here can recommend a Stainless welder/fabricator a bit nearer to Brighton, East Sussex ?

Thanks,

Boo2

Yes there a very good place in lancing, which is east of Worthing. Pipecraft. Done couple jobs for me very good quality metals as well,

Let me know if you want more info

 

[V1701]

They do it at Felton Marine, based at the marina but it will cost you...

 

[Seajet]

A bit further West but not too far to drive, Chris at CB Marine ( 01243 511273 ) is very good, and surprisingly reasonable considering his location, at Chichester Marina, the far CYC end.

 

[phanakapan]

As above, Bob at Felton Marine very good, not cheap but not silly expensive either.

 

[Boo2]

As above, Bob at Felton Marine very good, not cheap but not silly expensive either.

As a matter of interest can anyone tell me how much I can expect to pay as an hourly rate for marine stainless fabrication ?

Thanks,

Boo2

 

[V1701]

I needed some SS tubing bored out a wee bit when I was fitting my Navik, took about 20 minutes, they said normally charge min 1 hour but they charged me 1/2 hour and if I remember it was £30...

 

[Seajet]

These grab handles, made to my 'design' were about £100 the pair from Chris at CB Marine, Chichester Marina, about 3-4 years ago, so presumably a bit more now but still seems good to me.

 

[christhefish]

depending on what you want and how busy they are try pomfrey engineering in Newhaven have made a tank plus stanchion bases and other bits...not a marine shop but do an excellent job at fair prices