Silicon Spray for Protection

LONG_KEELER

LONG_KEELER

Well-Known Member
Joined
21 Jul 2009
Messages
3,720
Location
East Coast
Visit site
I buy it quite cheaply in pound shops.

Is it any worse or better than conventional spray grease for rust prevention ?

I seem to remember outboard motor manufacturers recommending it .

TIA
 
Only areas I use Silicon Spray is to stop hatches ... car doors ... windows .... locks ..... latches etc freezing ..... I buy the cheapest largest cans I can ....

Never noticed any difference from expensive 'purpose made' variety.
 
thinwater said:
In the US that would be a dollar store (vs. pound shop). Just a funny ideomatic difference. Lately, most of them have gone to $1.25.
Click to expand...
In Spain they are called "Todo a Cien" ... i.e. everything @100 Pesetas, which was approximately the Peseta/Euro exchange rate when the Euro was introduced. Hence Lidl's "Cien" branding on some of its low-cost products.
 
Laysula said:
I went to a dollar store in the US once and when I got to the till everything was a dollar + state taxes. :)
Click to expand...

I hate that ... spent a lot of time in US and it always annoyed me that Sticker price was misleading as it was PRE tax price. AND that each state has different tax levels ... with such as California with often more than one tax applied !!
 
Does ACF 50 contain silicone? I think it may well do but they are a bit shy about admitting it and it's difficult to find it confirmed in print.

I recently refurbished my stemhead fitting which had an attack of electrolytic corrosion under the bolts. As I had no waterproof grease to hand, so gave it a blast of silicone grease; too early yet to see if it does any good.
Have also used it on motorbikes, where it seems to perform as well as the old favourite Vaseline and probably stays a bit better. Can't say I can confirm this though.
 
doug748 said:
Does ACF 50 contain silicone? I think it may well do but they are a bit shy about admitting it and it's difficult to find it confirmed in print.

I recently refurbished my stemhead fitting which had an attack of electrolytic corrosion under the bolts. As I had no waterproof grease to hand, so gave it a blast of silicone grease; too early yet to see if it does any good.
Have also used it on motorbikes, where it seems to perform as well as the old favourite Vaseline and probably stays a bit better. Can't say I can confirm this though.
Click to expand...
Says no silicon of you look at the details on that page.
 
A long time user of ACF50 on my motorbikes, I usually paint it on with a small brush. It kind of stops existing rust in it's tracks but does need reapplying in areas that see weather. XCP rust preventer stays put for longer and is also very good...
 
I slather my bikes in acf50 for the winter, wash it off in spring - with some diffulty. It has the real drawback that it is sticky, so the bikes look like carp, but it works brilliantly. To the touch it's like a lightweight waxoyl
 
I use the silicone spray for genoa, mainsail and mast tracks. A real plus is you can use it on fabric/leather too without staining. Great for genoa sliding in foil and zips. I'll try it this winter on metal parts. As it's not sticky to attract dirt might be a plus.

I notice WD40 now does a " specialist silicone spray" which promises a number of benifits.

Quote
  • Provides up to 5X greater wear protection than the competition.* Our formula delivers the ultimate lubrication for less frequent reapplications.
  • Lubricates at least 2X longer than the competition**
  • Lubricates, waterproofs and protects metal and non-metal surfaces
 
Last edited:
You must log in or register to reply here.

Share this page

Top