steve66
Well-Known Member
i have one, i have made loads of 5l fuel tanks. I used to use it on the Ailsa Craig and an old Evinrude 6
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Refuelling Small Outboard with integral tank whilst on the water
- Thread starter dartmoor
- Start date
steve66
Well-Known Member
you need a standard 5 litre petrol plastic can and a spare cap, and some small diameter tube steel or copper and 2 rubber grommets that fits tight on the tube. Drill the cap twice opposite each other so the grommet fits in. Cut a small piece of pipe about an inch to use as a breather and push it into the cap. Pus the remaining tube through the cap making sure it reaches the bottom of the can. Connect the end of the tube to an outboard fuel line with primer bulb.Then when you have finished unscrew the cap off and replace with the sealed one that came with the tank.