Name in Vinyl Lettering

[Nina Lucia]

Do I have to have Name in Vinyl Lettering on sides and transom or just Name on port and starboard dodgers is enough?
Where is good place to get it made if need it,
I need it pretty quick, as we going back in the water next week?
Does any one make them at Beaulieu Boat Jumble tomorrow?
Thanks

 

[MoodySabre]

Just on the transom is enough unless you heading into European canals.

I got mine done while I waited at a local sign company that does vehicle graphics.

 

[Lakesailor]

Is the boat registered?
Otherwise it doesn't matter. Don't need a name.

 

[Nina Lucia]

Yep, boat is registered as a pleasure craft on Part I of the Register

 

[Rigger Mortice]

Do I have to have Name in Vinyl Lettering on sides and transom or just Name on port and starboard dodgers is enough?
Where is good place to get it made if need it,
I need it pretty quick, as we going back in the water next week?
Does any one make them at Beaulieu Boat Jumble tomorrow?
Thanks

There's usually somebody at Beaulieu who can make the signs up for you but I wouldn't panic about it. You're not likely to be shot at dawn if you haven't got everything quite right for a while.

 

[ctva]

... You're not likely to be shot at dawn if you haven't got everything quite right for a while.

Unless you go to France.

 

[Seajet]

I have always found SAC Graphics do an excellent job, I believe they have an express service if necessary; but it would not be unknown to stick the name on from the tender, just do it before going to the pub !

 

[Bojangles]

Try Funky Monkey, online orders, loads of options and very fast delivery, easy to apply. I've used them three times.

 

[greenalien]

Plenty of people on Ebay who'll do the job by return of post.

 

[BlueSkyNick]

Try Funky Monkey, online orders, loads of options and very fast delivery, easy to apply. I've used them three times.

I'll second that.

 

[Ubergeekian]

Yep, boat is registered as a pleasure craft on Part I of the Register

Then your carving and marking note will tell you. From memory, the boat name must and port of registry must be displayed on the transom, or for those of us without transoms (transae?) on both sides at the back. Again from memory, the name has to be at least 80mm high and the port 50mm.