eddystone
Well-Known Member
Currently aiming to do minimum necessary to get fresh antifouling to stick (I know some day I'll have to srape it back to the gel coat but that's in the future)
Noticed a lot of small round blisters in the rudder and a few other places - they are 2-3mm across and dry inside, no particularly strong odour. There was nothing like that the last time it was out of the water. Because I tried to patch up the bits where the antifouling had come off with Interprotect rather than primer (iit had been epoxied in the past) I wondered if its where it dint stick properly or went over anti foul?
Anyway my plan is to do nothing for the time being - one day I'll srape it all off and re-epoxy. Any different advice?
Noticed a lot of small round blisters in the rudder and a few other places - they are 2-3mm across and dry inside, no particularly strong odour. There was nothing like that the last time it was out of the water. Because I tried to patch up the bits where the antifouling had come off with Interprotect rather than primer (iit had been epoxied in the past) I wondered if its where it dint stick properly or went over anti foul?
Anyway my plan is to do nothing for the time being - one day I'll srape it all off and re-epoxy. Any different advice?
