Halyard 40mm exhaust/water separator - 2years old, little use

Puggy

Member
Joined
7 May 2007
Messages
391
Location
Hampshire, UK
Visit site
When i installed a new 6.5kw genny in 2016, i thought a water/exhaust separator would be a good idea to remove the annoying splash-splash of the exhaust. This unit did that nicely, but due to the configuration of my boat, it was installed in a cupboard in a cabin and it was just too noisy for the occupants. Probably best installed in the engine room or lazarette etc. So sadly I have removed it. It is a fine piece of kit with little use (the genny has only done 50hrs).

It cost £300 new, so I am asking £100. If I get no offers, I will put it on ebay and leave a note on this posting to say so. I will post it by ParcelForce at cost to purchaser to wherever Parcelforce will deliver to (nearly everywhere) or you can come and collect from near Andover, Hampshire. Cash on collection or if I am sending it a bank transfer first or paypal.

Thanks Puggy.

Install instructions here: http://www.halyard.eu.com/upload/downloads/waterseparators_1.pdf

IMG_0419 1.jpg
IMG_0420 1.jpg
IMG_0421 1.jpg
 
Last edited:
Top