Galley Pump Seal

[DOILY]

I have a plunger type, brass bulkhead pump made by Pump International of Camborne. Does anyone know, please where I can buy a replacement rod seal - the one that fits in the top screw on flange?

Pump International have stopped making the pumps and have no records to identify the seal.

Thanks very much.

 

[andsarkit]

Just measure the rod diameter and outside diameter of the seal and find one online.
Simply Bearings
An O ring might work but a lip seal is probably better.
If it is old it is more likely an imperial size.
You will probably end up with something better than the original.

 

[mikegunn]

I doubt that the seal was made specifically for the pump. It’s probably an off the shelf item. In which case I would recommend “simply bearings”. They carry a huge range of seals and bearings. Take a few measurements of the existing seal and look for an equivalent.
Mike

 

[Poignard]

If your pump is like my Whale brass plunger pump you might get the rod seal from FPE Fluid Power Ltd