Face Off Disk on angle grinder

[davidpbo]

Continue with the headlining project.

For the hull I found a wire cup brush best because it was all curved surfaces.

I have three small small flat panels to do off the boat. The adhesive is a bit gooey. I may try a face off disk. Are they best used flat on the surface or at an angle?

 

[Keith-i]

I used it with a slight angle. Whichever way, it is hard work and throws a lot of gooey 'snot' everywhere.

 

[Lakesailor]

You need to use them at a slight angle. However they are really easy to dig a groove into grp with.

 

[davidpbo]

You need to use them at a slight angle. However they are really easy to dig a groove into grp with.

And probably the same with wood. I persevere with cup brush.