JumbleDuck
Well-Known Member
Codswallop or not the only year i did not fill my tank for winter I found i had diesel bug the following season
Codswallop or not the only year i did not fill my tank for winter I found i had diesel bug the following season
That's the way most of us do at our yard, just a gentle reminder, DONT do as someone did, connected to bucket in cockpit, went home for dinner, came back to find water had syphened in to his engine!These days, with a nice safe marina berth in which to carry out all my pre-lift maintenance before the big day, I change my oil and filter on the water immediately beforehand. In the old days when the boat lived on an exposed mooring I always did it in the yard after haul out. Easily done, all you need is a water supply. Put a bucket in the cockpit filled with a hosepipe. Take a hose from it to the raw water pump and run the engine for ten minutes or more. Definitely do not remove thermostat and impeller. The oil will then be warm enough for a Pela, although it may still take some time to suck it all out, plus you have the bonus that the water side has been well flushed. Remove the impeller and
drain the exhaust trap to overcome any possible feezing issues.
However, the sky is not going to fall in if you don't change oil until the Spring. Not ideal but not a disaster. The condensation issue is a non-starter, half an hour under engine will vent all water vapour through the breather. But recent research into diesel tanks has shown that the old story about tanks breathing in atmospheric moisture was started by an old wife - no truth to it whatsoever. I feel certain that the same applies to crankcases.
That's the way most of us do at our yard, just a gentle reminder, DONT do as someone did, connected to bucket in cockpit, went home for dinner, came back to find water had syphened in to his engine!
Codswallop or not the only year i did not fill my tank for winter I found i had diesel bug the following season
I hang a bucket over the side so the water level is about the same as the normal waterline. The tube from the bucket jams nicely into the engine water inlet in the hull. Just need to be sure it is syphoning properly to start with - a clear tube helps.