Latestarter1
Well-Known Member
I know this issue quite often pops up on this forum from time to time and there are differing opinions of what represents a lot of engine hours for our boat engines.
For no reason other than being curious I popped on to some trucking forums to see what they are saying about average mileage as we have marinised of truck engines installed in our boats.
It would appear that some of us are perhaps getting a bit too worked up about the number of engine hours we put on our engines. The average truck does 100,000 miles a year with many doing a lot more when they are on double shifts.
So as a rough estimate, if a truck is on a double shift which I assume is 2 x 8 hours, then that's over 4000 hours per annum. Some of these trucks are running for a fair number of years so it seems 30,000 to 40,000 hours isn't impossible over it's working life.
So by comparison, the 1300 hours on my Volvos would suggest they are just about brand new!
Cor I thought I had done this to death a million times!
Marine vs automotive duty cycles bear no comparison whatsoever....
Consider this Volvo D13 460 rating (published B50 life 1.3 million kilometers) with Volvo I shift 12 speed transmission operating at 44 tonnes.
I shift will be doing a little dance keeping engine spinning around 1450 rpm at 56 mph, engine load will be cycling between 200/300 hp sometimes even less except on most extreme climbs.
Volvo Penta D13 700 marine engine, 690 hp @ 2300 rpm WOT running continuous output say 300 rpm off the top with propeller demand of 500 hp using 2.5 exponent.
Apples oranges and a few tangerines!
Live expectancy of heavy duty diesel engine in marine leisure market you will never wear it out so why is there any discussion?
Marine hang on bits (charge air coolers etc) a totally different story. Fuel filtration, a dirt particle the size of a red blood cell has the potential to bring a modern engine to its knees. Some injectors are now approaching 1k apiece.
Firefly has it right.
Last edited: