lw395
Well-Known Member
Fit an Adverc & battery monitor to give a good idea of whats going in & coming out
A voltmeter for about £4 is a good start!
Fit an Adverc & battery monitor to give a good idea of whats going in & coming out
Brilliantconnecting them in parallel may damage them ---- bollox
you'll never get a full charge on them ----- bollox
why are there no scientific explanations? 'cos there aren't any to be had!
+1 !A voltmeter for about £4 is a good start!
What is the truth of this matter and what principles of physics confirm (or deny) it?
Assuming you are at tickover, then you have little alternator output and low battery charge voltage, so poor or actually no charge, in which case disconnecting the service bank will see a small increase in engine battery charge volts. Either connected or disconnected without the alternator running at good rpm, you will see low charge volts.
Fit Voltmeter and ammeter showing net amps to / from service bank, charging till you see low current and high regulation voltage means you are at max nominal battery capacity, not 100% battery charge, to reach this level is a different world.
Brian
Brian
I'd agree with that.This depends on pulley sizes and ratio of the two one with respect to the other (ie alternator rpm at engine idle).
In my case 14V at engine idle enables battery charge from an engine idling with no load.
I have discovered one disadvantage of idling - exhaust elbow blockage!
This depends on pulley sizes and ratio of the two one with respect to the other (ie alternator rpm at engine idle).
In my case 14V at engine idle enables battery charge from an engine idling with no load.
I have discovered one disadvantage of idling - exhaust elbow blockage!