1 1/2 BSP Spanner???

[Plum]

Re: 1 1/2 BSP Spanner??? for skin fitting/seacock

If you are able to drill, cut and file a piece of 1/4 inch steel plate you could make your own crowsfoot spanner to use in conjunction with a 1/2 inch square drive socket set. I find this type is far easier in confined spaces where you can't swing a Stinson. Something like this http://www.ebay.co.uk/itm/NEW-Snap-...747155?hash=item360b6a4253:g:2JgAAOSwXeJYCJbw

Www.solocoastalsailing.co.uk

Every time I work on a skinfitting or seacock the hex sizes are never the same and access is always restricted so further to my previous post and spurred on by lw395 in post #20 I have made this adjustable wrench for tight locations out of a toolmakers clamp:-

www.solocoastalsailing.co.uk

 

[lw395]

Re: 1 1/2 BSP Spanner??? for skin fitting/seacock

Every time I work on a skinfitting or seacock the hex sizes are never the same and access is always restricted so further to my previous post and spurred on by lw395 in post #20 I have made this adjustable wrench for tight locations out of a toolmakers clamp:-

www.solocoastalsailing.co.uk

One day, I may want to borrow that!